How to Cut Perfect Circles With a Band Saw

May 14, 2020

Cut clean, smooth circles with your bandsaw

FH10JUN_PERCIR_01-2
Family Handyman Cut perfect circles with a band saw, using a simple jig. You can assemble the jig in about a half hour from ¾-in. plywood.

How to cut perfect circles with a band saw

Photo 1: Attach the runner

Cut 3/4-in. plywood to 16 x 24 in. Draw centerlines on both sides, then glue and pin the runner to the bottom. Send the jig through the blade until you reach the centerline, then clamp the auxiliary fence to the jigsaw fence.

Cutting perfect circles is easy with a band saw—as long as you take a half hour to build yourself a cutting jig. I’ve cut circles with radiuses ranging from a few inches to a couple of feet. The only limit is the distance from the fence to the saw blade.

Use any 3/4-in. plywood to make the jig, and attach a runner to the underside that fits in the band saw’s miter gauge slot. That will hold everything steady while you turn the actual circle stock through the blade. Then make yourself an auxiliary fence from another piece of 3/4-in. plywood as shown. Send the jig through the blade to create the saw kerf, then shut off the saw when the blade reaches the centerline and lock the fence about 1/8 in. away from the jig. Clamp the auxiliary fence to the band saw fence with the stop against the edge of the jig. Hold it slightly above the jig so the jig will slide easily beneath it. The auxiliary fence not only stops the jig at the right spot for turning circles but also keeps the jig from tipping up from the band saw table.

Cutting is simple. You’ll need to choose narrow blades for small circles. Push the jig with the mounted cutting blank until you reach the stop and then just twist the blank through the blade. You’ll have a small amount of cleanup to do where the cut starts and stops. You’re done.

Jig and Auxiliary Fence

The auxiliary fence provides a positive stop at the jig centerline and keeps the jig from tipping during the cut.

Required Tools for this how to cut a circle project

Have the necessary tools for this DIY how to cut a perfect circle project lined up before you start—you’ll save time and frustration.

  • Band saw
  • Brad nail gun
  • Circular saw
  • Clamps
  • Drill bit set
  • Drill/driver - cordless
  • Glue
  • Hammer
  • T-square
  • Tape measure

Required Materials for this how to cut a circle project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.

  • 3/4-in. plywood

source: Click Here

Get 150 Woodworking Plans And Guides For FREE

CLICK HERE
DMCA
Copyright © 2020 walterswoodshop.com
All Rights Reserved.
This site is not a part of the Facebook or Youtube website or Facebook/Google Inc.
Additionally, this site is NOT endorsed by Facebook or Google in any way.
FACEBOOK is a trademark of FACEBOOK, Inc.